Calibrating
The huddle that makes the recordings line up.
Calibration is what lets StakdTrax line the recordings up to within a fraction of a millisecond. It takes a few seconds, and it is worth doing every time.
The huddle

When everyone has joined, the host taps Everyone's here — calibrate.

- Bring all the phones together bottom to bottom, microphones touching, with the tops apart.
- Keep still. The primary phone plays a short sweep.
- When the sweep has finished, the host taps Done — everyone can spread out.
With three or four phones, bring every bottom into the middle — microphones touching, tops pointing outwards.

Hold them as close as you can: microphones five centimetres apart are already about seven samples out.
If someone moved, or the room was noisy, tap Play the sweep again.
Skipping it
Skip calibration goes straight to recording. The phones still keep their clocks in step over the network. That is close enough if you will cut between the recordings, but not for mixing them into one.
Map the room
Map the room appears once three or more phones are in the session; with fewer, it is not shown, because two phones give one distance and that is not a layout. It has each phone play a sweep in turn, so StakdTrax can work out where everyone is standing rather than only how far away each phone is. It needs about three seconds of quiet per phone.
When the round finishes, Where the phones are appears on the same screen: the phones drawn from above, each at its measured place and named — its band position where it has one. Tap the picture for the full map, every phone's coordinates, and Map the room again if anyone has moved.
Which way the room faces isn't measured, so the layout can come out rotated or mirrored. What it tells you is who stood near whom and how far apart, and the footer says how well the measurements agree — a layout that disagrees by more than a metre or so is a rough guide at best.
The same map is kept with the take afterwards, under Where the phones were in Your recordings. In a pipe band session that page shows the band's circle even if you never mapped the room.
Measure positions, on the recording screen, plays one sweep from the primary phone and works out how far away every phone is.
A phone that drops out
The calibrate screen shows the join code and QR code as well, so a phone that drops out can rejoin during calibration.